Innovo Wiki

Innovo Wiki

Loading the knowledge...

leaf leftleaf right

Neo Blinds Driver Information

ManufacturerNEO
ModelNeo Smart Controller
Driver NameNeoBlinds
Driver Version24.02.19.00
Document / Driver RevisionFebruary 19, 2024
Core Min / Max Tested8.7.605 / 8.8.xx

Neo Blinds Driver Description

This is a driver to control and receive feedback from Neo Smart Controller for blind controls.

Neo Smart Controller is compatible with most motorized systems and is compatible with major tubular motors

  • Allen+Roth, Alpha, Alta Bliss*, A-OK, Arabel,
  • Bofu/Simplicity (roller, vertical and top-down/ bottom-up),
  • Dooya, Dooya Bi-directional, Eclipse, Gaposa, Jiecang, Louvolite,
  • Maxxmar, MotionBlinds, Neo Smart Blinds, Nice, Raex, Rollease Arc,
  • Rollease Basic, Rollerhouse, Ronco, Somfy, Sunfree, Turnils AMP, Wistar.

Motor Codes Supported

“MOTORCODE”: code designation to indicate the motor protocol to be transmitted

“bf” : standard Bofu motor

“vb” : vertical Bofu motor

“tb” : top-down/bottom-up Bofu motor

“no” : NEO motor

“rx” : Raex motor

“nc” : Nice F-Code motors

“nr” : Nice 0-Code motors

“k1” : standard A-OK motor

“k2” : version 2 A-OK motor (Louvolite exclusive)

“k3” : version 3 A-OK motor (Eclipse exclusive)

“dy” : standard unidirectional Dooya motor

“by” : special code compatible with both Bofu and Dooya motors (deprecated!)

“wt” : standard Wistar and Alpha motor

NeoBlinds Device Setup

Install the blinds and add them to the Neo Smart Controller using the app.  For every blind or shade, find the Controller ID and Channels.  You will need those to install the device in Elan in the next step.

Finding Controller ID and Channels from APP

Using the app, go to each blind’s advanced page to find the necessary ID numbers.

  • You can get to advanced page by clicking on the name or icon in the App of the blind. 
  • Scroll to the bottom

See the image below.

Note, To create a single shade that will control all shades in the same room:

  • All blinds inside the same ROOM have the same unique combination of Controller ID codes.
  • To control all blinds at once, add a curtain device and use CHANNEL = 15 to control all blinds as a group.
    • In the example above, the Blind Code will be 242.210-15
  • To control individual blinds, use the indicated Motor Channel.
  • That’s the same behavior found using physical remote controls.

NeoBlinds Driver Configuration

Installation Process

Install the driver under Lighting Controller. 

1. Add the Activation Key received from Innovo

2. Add the IP Address of the NeoBlind Controller
  • Under the lighting driver, Add New Device as Shade or On/Off Device
  • Enter the Blind Code and Motor Code found in the previous step

NeoBlinds Using the Driver

Operate the Blind or Shade Open / Close / Stop