¶ Integration Note
| Manufacturer | Leviton |
| Model | Decora Wi-Fi Firmware1.4.32 or higher, CP 1.13 |
| Driver Name | Leviton Decora Wi-Fi |
| Driver Version | 24.02.05.00 |
| Document / Driver Revision | Feb 5, 2024 |
| Core Min / Max Tested | 8.5 Build 18 |
¶ Overview
This is a two-way driver to control and get feedback from supported Leviton Decora Wi-Fi smart light products.
¶ Supported Features
THE FOLLOWING OPTIONS ARE SUPPORTED :
- This Driver supports
- Auto Discovery and Installation of All supported lights
- On/Off using network
- Control Dimming Settings
- Read Feedback from the lights
- Sync with the lights if changes occur outside of Elan
- Only Decora Models with Wi-Fi features with Firmware 1.4.32 or higher, CP 1.13 are supported by this driver. As of the writing of this document, the driver supports the following model numbers (Most likely if the model supports Wi-Fi, this driver can run it):
- DW6HD 600W Dimmer
- DW1KD 1000W Dimmer
- DW3HL Wi-Fi Plugin Dimmer
- DW15P Wi-Fi Plugin Outlet
- DW4SF Fan Speed Controller
¶ Driver Configuration
- The Driver uses the Leviton Cloud. An active internet connection must be present at all times.
- Install the My Leviton App connect it to the cloud account and ensure it operates the Lights unit directly from the app.
¶ Installation Process
IMPORTANT NOTE:
It is recommended that you follow the below installation process to make sure you are running the latest version of the [driver].
- Open Lighting, Lighting Interface, Add New Lighting Interface
- Navigate to the folder where the driver is located and Choose the Govee → OK
- You’ll receive a warning that this is not a Native Elan driver, click OK
- The Driver will automatically go into trial mode for 30 days. Wait for about 10 seconds and the Status will turn Green.
- Add the Innovo Activation Code received in the email.
- Add the My Leviton App username and password
- Set the Polling time – This is the time that Elan will use to sync in case light settings change outside of Elan. If Elan will be the only interface, set this value as large as possible
- Click Apply the Get Devices. The driver will populate all devices connected to the account.
¶ Configuration Details
The following table provides settings used in Configurator …Please refer to the Configurator Reference Guide for more details.
In the table below:
- “<User Defined>”, etc. Type in the desired name for the item.
- “<Auto Detect>”, etc. The system will auto-detect this variable.
| Devices | Variable Name | Settings | Comments |
| Lighting | Name | User Defined (Default: Leviton Decora) | |
| System # | <Auto Detect> | ||
| Device Type | Ethernet | ||
| Driver Name | Leviton Decora Wi-Fi | ||
| Driver Version | <Auto Detect> | ||
| Driver Vendor | Innovo | ||
| Activation KEY | <User Defined> | ||
| IP Address | NONE | Cloud Based | |
| Display Name | <User Defined> (Default: Govee) | ||
| System # | <Auto Detect> |
¶ Using the Driver
- Add an interface to control the lights from Lighting → Custom Pages
- Create the necessary controls, such as dimmer or button.
- Connect the Elements to the proper variable in the driver.
¶ Troubleshooting
- Driver not Activated. Wait 15 seconds after Apply