¶ Integration Note
| Manufacturer | Shelly |
| Model | Shelly Pro PM |
| Driver Name | ShellyPMPro |
| Driver Version | 24.08.09.00 |
| Document / Driver Revision | Aug 9 , 2024 |
| Core Min / Max Tested | 8.8.603 or higher |
¶ Overview
This is a driver to read and update Current, Power, Voltage, and last reported values from Shelly PM Gen 2 and Gen 3. Readings are updated live as the devices reports them. This driver doesn't poll but rather listen for broadcast from the device.
NOTE: The Driver will be able to install different Types of PM devices.
¶ Device Configuration
This will only work right on the Nice Core 8.8.603 or higher.
You must have Multicast, IGMP Snooping, and Broadcast enabled on your network including the wireless segments
On your Shelly PM device, make sure to do the following:
¶ Device Setup:
Using the Shelly App (this doesn’t work from the Web Interface of the Shelly Device)
Open the back of the Shelly PM Device and have the pairing button exposed. When you click the button within a few seconds, you will see the message “SEt” This means that device is on the network and in pairing or writing mode. You will need to do this several times during setup and installation of the driver.
¶ Driver Configuration
¶ Installation Process
- install one driver per PM device. There is no auto discover option. Each PM must be installed using the same process below.
- Add the driver under Utilities –> Energy Devices
- Change Name, Display Name
- Enter IP Address of the PM, Enter Activation Code if any (if no activation code the driver will default to 30 day trial)
- Hit Apply.
- Click off the utilities tab into any other tab, then come back the Utilities tab, then the driver. If all goes well, you should see the INPUTS listed at the bottom of the driver screen.
Open the Interfaces, Utilities tab and add the driver to the desired Interface.
Click The right arrow and then hit apply.
- To Set Triggers or adjust Min / Max Values, and change the input name → Open the Input / Output tab, go to Numeric Inputs and Adjust as needed.
¶ Using The Driver
¶ Create a custom page
You can also create a custom page and add each gauge individually. following this link