¶ Integration Note
| Manufacturer | Shelly |
| Model | see List |
| Driver Name | Various, See List |
| Driver Version | Varies |
| Document / Driver Revision | Oct 10, 2024 |
| Core Min / Max Tested | This will only work right on the Nice Core 8.8.603 or higher. |
¶ Overview
Shelly Drivers have been split into the following drivers to accommodate more functions and better Nice Integration. :
Shelly Pro - This will install supported lighting devices from Gen1, Gen2 & Gen3. It will also install the lighting switch portion of PM and EM Gen 1 & Gen 2 devices. This will also install all Gen 1 Sensors.
Shelly Utilities (This Driver) - This will install all Gen1, Gen 2 and Gen 3 Energy monitoring, power monitoring and T&H monitoring devices. This uses the Elan Utility tab.
Shelly Climate - This will install the Shelly TRV under the climate tab.
Shelly Uni Plus - This will install the Shelly Uni Plus under the Utilities tab. We also have a version of the Uni Plus designed for the Garage Doors available in our Garage Pro driver.
You must have Multicast, IGMP Snooping, and Broadcast enabled on your network including the wireless segments. Make sure your router allows those values.
¶ Models Supported (The utilities driver supports the energy / power / sensor section of these devices)
¶ Shelly HT Devices
For Integration Note Click Here
¶ Shelly PM devices
For Integration Note Click Here
- Shelly Plus 1PM UL
- Shelly Plus 2PM
- Shelly Plus 2PM UL
- Shelly Plus Add-on
- Shelly Plus Plug IT
- Shelly Plus Plug S
- Shelly Plus Plug UK
- Shelly Plus Plug US
- Shelly Plus Wall Dimmer
- Shelly Plus RGBW PM
- Shelly Mini devices
- Shelly 1PM Gen3
- Shelly Dimmer 0/1-10V PM Gen3
- Shelly Mini PM Gen3 devices
- Shelly Pro 1PM
- Shelly Pro 2PM
- Shelly Pro Dual Cover/Shutter PM
- Shelly Pro Dimmer 1PM
- Shelly Pro Dimmer 2PM
- Shelly Plus 1PM
- Shelly Pro 4PM
¶ Shelly Pro 3EM Devices
For Integration Note Click Here
¶ Shelly Pro EM Devices
For Integration Note Click Here
¶ Device Setup:
¶ Gen 1 Devices
- Enable COIOT by manually entering a multicast address with a port.
- Go to settings under Internet → Security → Advanced → Developer Settings
- Enable CoIot
- Set the Remote address to
mcastCopy
Copy
- NOTE: If the devices still doesn't report after setting mcast, change the Remote address to
224.0.1.187:5683Copy
Copy
- Hit Save, then Reboot the Device —> Settings —> Reboot (You must reboot the for changes to take effect)
¶ For Gen 2 Devices
For Gen2 Devices, enable RPC over UDP. Enter the Destination Address as 224.0.1.187:5683 and the Listening Port as 5683.
