Input Driver Configuration

Installation Process

It is recommended that you follow the below installation process in order to ensure you are running the latest version of the [driver].

• Open Input/Output Section, Communication Devices, Add new Communication Device.
• In V2, click Import MagicCubeInputPro driver.  In V1, Navigate to the folder where the driver is located and Choose the MagicCubeInputPro driver, OK
• If you receive a warning that this is not a Native Elan driver, click OK

• The Driver will automatically go into trial mode for 30 days. Wait for about 10 seconds and the Status will turn Green
• Add the Innovo Activation Code received in the email.
•  Starting with Magic Cube Aura and V5 Patch 3, you no longer need to add the token.  The token is added using the Magic Cube Admin Interface.  See Magic Cube User Manual
• Click Apply.
• Click Discover, and the driver will discover and populate the IP address of the Magic Cube device on the network.  If the device is not discovered or you have more than one, enter the IP address manual.
• From the Platform dropdown, choose the brand of sensors you would like to install. 
• NOTE: You must have the brand/platform preconfigured in the Magic Cube First.  See Magic Cube Manual.
• NOTE: If the platform you want to install is not shown on the platform dropdown, then contact support@innovo.net to get the exact name of the platform you want. After you get the exact name, choose Other from the platform dropdown, enter the name you have in the Other Platform Field, click Apply, and install.
• NOTE: To continue installing platforms from the dropdown you should have the Other Platform field empty

• Click Install Devices.  The Driver will automatically discover all sensors connected to the Magic Cube and install them under Input Controllers as a sub driver based on manufacturer.

If you need to add more sensors in c future, click on Install Devices.