Lea Driver Configuration

Installation Process

It is recommended that you follow the below installation process in order to ensure you are running the latest version of the driver.

• Open Media, Zone Controllers, Add New Zone Controller.  (The version of the driver may not be the same one as pictured here.)

• You’ll receive a warning that this is not a Native Elan driver, click OK
• Enter the IP address of the device (this is show on the front of the AMP)
• Click on Get Device info
• The driver will then read the amp’s input / output devices and configure the driver accordingly.

• Add Sources / Zones as needed. 

NOTE:  The driver will always add an extra Source for Each 2 Channels of the Amp at the end called “Analog 1 + 2 or Analog 3 + 4, etc” depending on how many channels the amp has.