Innovo Wiki

Innovo Wiki

Loading the knowledge...

Climate Driver Configuration

Estimated reading: 3 minutes

Each Climate device is setup differently.  Each device must be setup in Magic Cube on the Magic Cube first.  Then the driver will automatically pick it up.

1.    Nest: This is now an Elan native driver.  No Magic Cube Required. 

2.    Trane / Nexia / American Standard:

Nexia/American Standard/Trane can be auto-discovered by the Magic Cube running Magic Cube. If an instance was found, it will be shown as “Discovered”, which you can select to set it up right away.

If it doesn’t auto discover

  • Browse to your Magic Cube instance.
  • In the sidebar click on  Settings.
  • From the configuration menu select: Devices & Services.
  • In the bottom right, click on the  Add Integration button.
  • From the list, search and select “Nexia/American Standard/Trane”.
  • Follow the instruction on screen to complete the set up.

Please reach out to for the following systems


IntesisHomeAirconwithme and anywAIR




Any other system that is supported by Magic Cube.

Installation Process

It is recommended that you follow the below installation process in order to ensure you are running the latest version of the [driver].

  • Open Climate, Communication Devices Interface, Add New Climate Communication Device.
  • In V2, click Import MagicCubeClimatePro driver.  In V1, navigate to the folder where the driver is located and Choose the MagicCubeClimatePro driver OK
  • If you receive a warning that this is not a Native Elan driver, click OK
  • The Driver will automatically go into trial mode for 30 days. Wait for about 10 seconds and the Status will turn Green.
  •   Add the Innovo Activation Code received in the email.
  • Starting with Magic Cube Aura and V5 Patch 3, you no longer need to add the token.  The token is added using the Magic Cube Admin Interface.  See Magic Cube User Manual
  • Click Apply
  • Click Discover, the driver will discover and populate the IP address of the Magic Cube device on the network.  If the device is not discovered or you have more than one, enter the IP address manual.
  • From the Platform dropdown, Choose the brand of the climate you would like to install.
  • NOTE: You must have the brand/platform preconfigured in the Magic Cube First.  See Magic Cube Manual.
  • NOTE: If the platform you want to install is not shown on the Platform dropdown, then reach out to, the values are very specific and case sensitive. Then you can choose other from the dropdown, and in the Other Platform field write the platform you want to install.
  • NOTE: If you want to continue installing devices listed in the platform you should have the Other Platform field empty.
  • Click Install Devices.  The Driver will automatically discover all climate devices connected to the Magic Cube and install them as sub drivers under Thermostats based on manufacturer. 
  • NOTE:  If you change the name of the TSTAT in Elan configurator, Click on Install / Reload to update the name.
  • From the Setpoint Upper/Lower Limit dropdown, you can choose the setpoint limit for your thermostats.
  • If you need to add more climate devices in the future, click on Install Devices.