Z-Wave

When equipped with a Z-Wave adapter, the Magic Cube becomes a powerful Z-Wave Controller. Dare we say, it can replace your Vera Edge!

The Aura can support Z-Wave 800 (LR) and is backwards compatible with 500 and 700. You must use an approved adapter.

We have tested and approved the following adapters with the latest firmware > 7.19 (by default if purchased from Innovo, the adapters have the latest firmware)

The Magic Cube Aura uses ZWave JS UI as it’s engine. It also allows for full Z-Wave administration from the JS UI’s dedicated dashboard or directly from Home Assistant. Innovo has setup, installed and configured the Z-Wave engine to be ready for use with Home Assistant and your home controller. No configuration is necessary.

Z-Wave JS UI is extensive and has lots and lots of features. The full documentation is here

This document relies on your dealer training and knowledge with Z-Wave and serves only as a basic guide to setup a device and bring it in to your control system. If you are not familiar with Z-Wave, Google is your uncle.

Getting Started

Plug in your Z-Wave Adapter Verify that the Z-Wave service is running

Adding Adapter and Devices Using JS UI

Before starting verify that your ZWave Adapter is recognized and working. You

Adding Adapter and Devices Using Home Assistant

Before starting verify that your ZWave Adapter is recognized and working. You

Troubleshooting Z-Wave

If you have problems with you the Z-Wave, follow the Golden Rule