Innovo Wiki

Innovo Wiki

Loading the knowledge...

GaragePro RedBox Setup

Estimated reading: 2 minutes

Programming Guide for RF Garage Door Opener.

 A. Program the Remote in the Red Box

  1. Confirm the Color of your Learn Button on the Garage Door.
  1. Open the Red Box using a screw driver.
  2. Power the Red Box with the provided power supply (12 V / 1 A or 12 V / 2 A)
  3. Press and Hold Button 2 and 3 together for about 3 seconds until the RED LED lights up and stays on.  This means the Remote is ready to program.

Note: To program the opener, we only use button 1 for the trigger.

  1. Click Button 1 according to the table below matching the color of your learn button.  For example if your learn button is Purple, Press Button 1 twice.
  1. After Pressing Button 1, press button 2 or 3 to confirm.   This will program the remote.

B. Program the Garage Door Opener

  1. Bring the Red Box close to the Garage Door Opener.
  2. Press the learn button on your garage door.  The garage door LED light should stay on
  1. Press Button 1 on the remote in the Red Box.  You should see the opener’s light flash twice or hear an audible confirmation (usually two clicks)

NOTE: After pressing the learn button, the LED usually stays on for 30 seconds.  After completing step 2, pressing the learn button a couple of more times will help complete the process.