Intellifire Driver Configuration

Installation Process

The Driver has two Drivers files.  Each is installed separately.  You can choose to install the device as a Thermostat or as a Lighting Device or Both.

Driver 1 – intellifire.edrvc

The Driver installs the climate section of the device.  This is used to control Flame Height, On / Off, Auto (Thermostat Mode), Fan Level, and Setpoint when operating in thermostat mode (auto)

From the Climate Tab, Add Communication Device, Find the driver and install it.

1. Add the Activation Key received from Innovo 2. Add the Intellifire App Username / Password 3. Set the Polling time,  Minimum is 3 minutes, but set it to longer if the Fireplace is rarely used such as in Summer or Vacation homes. 4. Set Dwell Timer.  Dwell timer is for error messages that can be used to trigger event maps.  During a dwell time, a trigger will only happen once.  Once the error message has cleared the triggers will not occur.

Very IMPORTANT: Under Each Climate Device, Disable Scheduling

IMPORTANT:  Disable Climate Schedules in Elan.  This driver does not support Climate Schedules. Enabling this will lead to erratic behavior.  The fireplace is not a true thermostatically controller unit and will not respond to standard commands.

If you need scheduling, install the lighting driver and use the light schedules in Elan to set Flame Height.

To Use scheduling in Elan, use the Lighting Schedule for Flame Height Control.

Under Heating / Cooling Unit set Default Unit Controls Cooling to No

Driver 2 – intellifirelighting.edrvc

Install this as a Lighting Interface.  This driver is used to control any light features that fireplace might have. This is also used to control the Pilot feature (Cold Weather)