Honeywell Driver Configuration

Installation Process

IMPORTANT NOTE: 

It is recommended that you follow the below installation process in order to ensure you are running the latest version of the [driver].

• Unzip and Extract all EDRVC Files from downloaded file into the Driver Installation folder.
• Open Climate, Communication Devices, Add New Communication Device
• Navigate to the folder where the driver is located and Choose the Honeywell Home Driver

Note:  If the driver doesn’t appear under the Communication Type then make sure that the Honeywell Home driver is extracted to the same folder where all the other drivers are installed from.  It’s good practice to create one folder on the computer where all the third party EDRVC files live.

NOTE:   If the driver still does not appear, do the following:

1. Extract the downloaded zip file to you EDRVC folder (the folder where all custom EDRVC drivers live)
2. Go to Thermostat, then add a Honeywell Home driver.  Then Delete it.
3. Now go back to Communications device, Add, Check the box the says show unsupported devices, the Driver should show up on the bottom. 

• You’ll receive a warning that this is not a Native Elan driver, click OK
• The Driver will automatically go into trial mode for 7 days.  Wait for about 10 seconds and the Status will turn Green. 
• Enter the Driver activation key from Innovo and the Consumer Key / Consumer Secret from the app you created on the Honeywell developer website.  Click Apply.

• Click Authorize

You will be Taken to the Honeywell Authorization page where you will use your very particular set of skills that you have acquired over a very long career to add your App user credentials, then Allow and connect the necessary thermostats

• Once the authorization id done, close the Elan confirmation page and go back to the configurator.

• Click Yes on save changes, then Click Get Devices

• The driver will then Automatically Install
  • All the thermostat units attached to the Honeywell Home account
  • A default Heating/Cooling Unit.
  • Supported operating and fan modes for the system